Weather Stripping Doors

professional garage door repair Tempe AZ

Sealing the gaps around the doors in your house is extremely critical for reducing drafts and lowering energy loss. Although these little spaces might look trivial, they can amount to some major loss of energy. To make this understandable, a narrow gap of simply 1/4 inch at the base of an entry door amounts to having a 3-inch square hole in the middle of your door. So, as you can see, among the very best house enhancement jobs you can do is to use weatherstripping to the doors in your house.

When a door is closed, warm and cool air can get away in between the door jamb and the door. You will get both more coziness and a boost in energy conserving by securing those voids. Make sure to get professional garage door repair Tempe AZ to stop your garage door from leaking the heat.

To start this house enhancement job, you have to take your supplies outside. When you are prepared to start, close and lock the door so that is it closed firmly. Measure the peak of the door from the edge of the door stop on the left to the door stop on the right. (The door stop is the trim that runs along the door all around). After that take those dimensions and mark the weather strip. Use snippers to cut the strip at the mark you made. Make certain it fits correctly and after that put the piece of weather stripping at the top of the door stop, however make certain not to push it too hard into place so that the door will open hard. Next take the screws that are supplied and drive a screw into the middle hole on the metal strip. Do this up until all of the screw holes have screws in them. If you start in the center and work toward the ends you will have put uniform pressure along the whole strip, making sure a great tight fit.

professional garage door repair Tempe AZ

The next action is in this DIY house enhancement job is to set up the weatherstripping on one side of the door. Measure from the piece of weather-strip that you simply applied to the threshold plate at the bottom of the door. Take these measurements and cut your piece of weather stripping. Afterwards put the weather strip against the door and secure it to the door stop the similar way you did for the very first piece. Now proceed and do precisely the very same thing for the other side of the door and set it up in the same fashion.

Now that you have all 3 pieces set up, you need to go inside and close the door firmly. Check around the whole door for any sunlight. If you can see any light at all peeping through, then return outdoors, close and lock the door once again and get rid of the screws in that place that you saw the light and press the stripping in a little harder, then just place the screws back in once again. Repeat this around the whole door up until you no longer see light when inside watching out.

Weather-Stripping Tips